[Beemer]

I have two points:

(1) Tried XP-ISO-builder for the first time and it crashed at stage 8 error ntdll.dll Hopefully this was not a program problem.

(2) I have selected that XP authentication be done but this wold not be possible until my network controller is added. So when does XP-ISO-builder add my chipset and network controller?

(3) I have a Gigabyte GA-EP45-DS3P motherboard and the setup disk. For an unnattended slipstream how should I select the setup? I do not know whether I should select the cdrom root setup file or the separate driver exe?

regards und danke!

Beemer

[Fernando]

Zitat (Beemer: 15.11.2008, 16:46)

I have two points:

I counted three of them.

Zitat

(1) Tried XP-ISO-builder for the first time and it crashed at stage 8 error ntdll.dll Hopefully this was not a program problem.

Probably not. Retry it.

Zitat

(2) I have selected that XP authentication be done but this wold not be possible until my network controller is added. So when does XP-ISO-builder add my chipset and network controller?

When you have integrated them, they will be installed during the GUIMODE part of the installation. So you will able to use the devices from scratch (if you integrated the suitable drivers).

Zitat

(3) I have a Gigabyte GA-EP45-DS3P motherboard and the setup disk. For an unnattended slipstream how should I select the setup? I do not know whether I should select the cdrom root setup file or the separate driver exe?

What do you mean with "SETUP DISK", "CDROM ROOT SETUP" and "DRIVER EXE"?
Usually you get with the mainboard a manual and a CD with the suitable mainboard drivers.
I do not recommend to take them, because they usually are very old.
Check the support sites of the manufacturer of your onboard hardware devices (chipset, network controller, audio chip etc.) for the newest drivers.

CU
Fernando